Well what I did was slow down the project to slip it into my range. But! When I return back to normal speed it sounds like freaking Micky Mouse. Any EQ tricks I can do to fix this? Yoyr help[(as always)is grreatly appreciated. Bardo

I'm not sure,Is that in Project settings? I was slowing it down using the middle slide bar.

What I'm trying to do is lower the pitch of the WHOLE project so the Vocal part is in my range. Sing the part. Then return the project to it's proper speed. When I play the vocal back it is in the correct pitch and speed but the tone is thin and nasel sounding. Bardo

Ok,I'll give it a whirl. Thanks abgain for the help Jason!

Ok,i have set elastique pro 2 to a formant preserving setting. But which opition? Lowest to highest mid? Bardo

Well I'm singing a higher part(harmony)but want to maintain the "timber"of my voice. I think the mid should do just fine. Even if the timber sounds a little thin.(backgrounds VOX should be on the thin side right?)

Also, try to pitch the project down without lowering the playback speed and just leave it there in that key where your vocal range is. Select all parts (except drums) and pitch them down 3 half-steps or whatever. I never tried it with an entire project so I can't comment on how it might sound.

Thanks guy's! Bardo

Cool! I'll go try that now. Thanks GTRKEYS